Support Center

SCR testing using 815 component tester

Last Updated: May 01, 2014 03:28PM PDT
Applicable Model:  815

How to test a SCR using 815 component tester

If you have a B&K Precision model 815 and you want to test SCR, this article will help clarify the pin configurations for your testing.

Refer to this image:
815.jpg

1.  Set the meter to SCR mode.  This is indicated by the SCR icon highlighted in a red square in the above image.
2.  The red circled letters are described as:
K - Cathode
A - Anode
G - Gate

3.  Insert or wire to your SCR to the appropriate pins for correct measurement.

Note:  There are 2 "K" pins, but both are the same and you can use either of them.
178af1a33e8bb83a5155805675912147@bkprecision.desk-mail.com
https://cdn.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete