Support Center

Extended Remote Commands for 2831E and 5491B Multimeters

Last Updated: May 01, 2014 03:51PM PDT
Applicable Models:  2831E, 5491B

The attached downloadable documentation (below) in this article includes an additional set of SCPI protocols for remote communication.  These commands are an extension from the original firmware release of the product.  For multimeters of the above applicable models that were purchased after September, 2010, included firmware can support these additional commands.

Users who purchased their multimeters before this date can contact B&K Precision to inquire information about upgrading their firmware.
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found